<![CDATA[Both lan version and Bambuddy printer displayed in slicer]]>Hello,
I tested a setup using archive and queue and Proxy. When using archive and queue on the device tab the printer selection shows both the VM printer setup and the direct name from the printer (LAN). How can I setup to ensure that just the one from Bambuddy is displayed?
Note when I setup using Proxy option I do not have this issue.
Below is screenshot of slicer.
When doing archive or queue option how can I just have the virtual printer show in bambu slicer?

Bambuddy duplicate printer shown in slicer.png

]]>https://forum.bambuddy.cool/topic/66/both-lan-version-and-bambuddy-printer-displayed-in-slicerRSS for NodeWed, 24 Jun 2026 05:41:13 GMTWed, 27 May 2026 03:21:33 GMT60<![CDATA[Reply to Both lan version and Bambuddy printer displayed in slicer on Thu, 28 May 2026 05:36:44 GMT]]>If your slicer can reach your physical printer directly, VP mode proxy is not the right one for you. You either need to use one of the other VP modes or make sure that the slicer cannot reach the physical printer directly.

]]>https://forum.bambuddy.cool/post/138https://forum.bambuddy.cool/post/138Thu, 28 May 2026 05:36:44 GMT<![CDATA[Reply to Both lan version and Bambuddy printer displayed in slicer on Thu, 28 May 2026 00:17:58 GMT]]>Logged out and even restarted the laptop. Still shows.

]]>https://forum.bambuddy.cool/post/137https://forum.bambuddy.cool/post/137Thu, 28 May 2026 00:17:58 GMT<![CDATA[Reply to Both lan version and Bambuddy printer displayed in slicer on Wed, 27 May 2026 07:01:19 GMT]]>Logging out of it?

]]>https://forum.bambuddy.cool/post/133https://forum.bambuddy.cool/post/133Wed, 27 May 2026 07:01:19 GMT