Ok, I think this was a firmware issue, my A1 mini was freaking out until I updated it to the most recent version. I had things set up properly in Bambuddy, but adding the A1 mini's virtual printer to Bambu Studio or OrcaSlicer resulted in an 'Incorrect Password' error. After updating the firmware and refreshing the access code everything is working correctly!

@MartinNYHC I'm not sure what you mean, could you elaborate?

Hello,

I'm brand-new to Bambuddy and trying to get up and running on Windows native.

I have a P1S and an A1 mini that I'd like to use over Tailscale, but for the life of me I cannot figure out how to get both printers working at the same time.

I'm able to get one working at a time, but not both, seemingly because of the Bind Interface option. If I set this option to anything other than the Tailscale IP, nothing works, but only one VP can use the Tailscale IP at a time.

Any help would be greatly appreciated!