Prints start paused
-
Every print I start, gets paused because there's something on the buildplate. But there isn't. I checked the workflow setting "Plate Clear Confirmation". because I thought it has something to do with it. I even tried the slider both ways, in case it has (accidental) reverse logic. Never had it before I switched to Bambuddy. The printer itself isn't complaining about anything, it's Bambuddy. But I do have to resume the print otherwise it stays paused.
What's going on? -
My understanding is that if you have print plate confirmation checked, the print will not start till you set the plate as cleared on the printer page. Also, on the printer card, check if you have plate check enabled. It uses an image detection algo to check if there is something still on the build plate. I've found it to have too many false positives, so I just disabled it and am relying on plate clear confirmation. Check the screenshot to see the plate check toggle I am referring to.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login